Unlocking DB2012 - CID52 based phone with CS TestPoint Unlocker

Cruiser Suite SE TestPoint Unlocker is an application for unlocking SonyEricsson phones. Currently supports only an Unlock-by-Patch, so the phone must be previously flashed with the desired firmware.

Currently supported platforms:

• DB2012 - CID52 only

Currently supported phones:

• Sony Ericsson W200
• Sony Ericsson W300
• Sony Ericsson W810

Installation

1. Run the installer file and follow the installation wizard’s instructions

Cable

Cruiser Suite SE TestPoint Unlocker requires a new Cruiser UC20 cable. The Cruiser UC20 cable consists of:

• a data cable
• power supply clips
• a testpoint needle

Preparation

1. Make sure the phone has the desired firmware already, otherwise flash it with your favorite flashing tool.
2. Prepare the phone for the testpoint unlock.
   - remove the phone cover
   - make sure the Pin27 is clean and accessible

Note: we recommend to use a binocular microscope for either preparation and testpoint connecting

Unlocking procedure

1. Make sure Cruiser+ Dongle is plugged in your computer. Card ID must end with “-07”.
2. Run SeTestPointUnlocker.exe
3. Choose the phone model.
4. Connect the data cable and power supply clips to the phone.
5. Double-click on the appropriate cruiser UC20 serial cable.
6. Wait until the program asks you to connect the testpoint.
   
   
7. Connect the testpoint needle to Pin27.
8. When informed, the testpoint may be released, the program continues with unlock procedure.
9. Disconnect the cabling from the phone when program finishes.